Electric Gate Repair in Brighton

Brighton has a particular set of problems for electric gates. Salt-laden air off the Channel corrodes tracks, hinges, motor housings, and electrical connections faster than anywhere inland. Steep driveways in Woodingdean and Bevendean put extra mechanical load on motors. Conservation area restrictions in Kemp Town and the Regency squares mean you cannot simply swap a gate for something easier to automate. Whatever the fault, the gate needs fixing properly by someone who understands coastal installations.

We cover Brighton from our base in Horsham — roughly 40 minutes via the A23. Your engineer carries common parts for CAME, Nice, and BFT systems and completes most residential repairs in a single visit.

Repair callout: £225+VAT | Emergency same-day: £270+VAT

Call us: 07542 024681 | Book online

What We Repair in Brighton

Salt Corrosion Damage

The single most common issue on Brighton gates. Salt air attacks every exposed metal surface — hinges seize, motor casings pit, electrical terminals oxidise, and control board traces corrode. Properties within half a mile of the seafront are worst affected, but salt damage reaches well inland to Withdean and Patcham. Your engineer cleans corroded connections, replaces damaged terminals, applies marine-grade grease to bearings, and recommends stainless steel fixings where the originals have failed.

Motor Failures on Steep Driveways

Brighton's hillside properties — particularly in Woodingdean, Bevendean, and the upper reaches of Elm Grove — have driveways that slope steeply from the road. Gates on inclines work harder to close against gravity, which puts extra strain on the motor and gearbox. CAME motors are common on these properties. Your engineer diagnoses whether the fault is mechanical wear, a blown capacitor, or a control board issue, and repairs accordingly.

Photocell and Sensor Problems

Seagulls perch on photocell brackets and knock sensors out of alignment. This is genuinely one of the more frequent callouts in Brighton — a gate that opens but refuses to close, or closes and immediately reopens. Your engineer realigns sensors, replaces damaged brackets, and can install protective housings where bird interference is persistent.

Conservation Area Gate Repairs

Kemp Town, the Regency squares, and parts of central Brighton are conservation areas. Gates in these zones often have period ironwork that cannot be replaced without planning consent. We repair the motor, control board, safety devices, and wiring without altering the gate itself — keeping the installation compliant with conservation restrictions.

High-Cycle Gate Wear

Shared-access gates on converted Victorian villas and blocks of flats in Brighton cycle 15 or more times daily. This accelerates wear on every moving component — drive gears, limit switches, bearings, and hinges. We identify which components have worn beyond tolerance and replaces them before the gate fails completely.

Common Gate Types in Brighton

How a Repair Visit Works

1. Call or book online — describe the fault or just say the gate has stopped
2. Your engineer arrives — typically within 3-4 days for standard bookings, same-day for emergencies
3. Diagnoses the problem — inspects motor, control board, sensors, safety devices, wiring
4. Repairs on site — most residential repairs completed in one visit
5. Tests and reports — gate cycled multiple times, written report provided

Pricing for Brighton

Parts charged separately at cost. Always quoted before ordering.

Areas Covered Near Brighton

We also covers these nearby areas:

• Electric gate repair in Hove
• Electric gate repair in Steyning
• Electric gate repair in Worthing
• Electric gate repair in Eastbourne

Also covering: Withdean, Preston Park, Tongdean, Kemp Town, Woodingdean, Rottingdean, Patcham, Hollingbury.